Jump to content
Model Cars Magazine Forum
花火

Any idea how to remove a decal?

Recommended Posts

I want to remove some decals from one model but I just want to take them down from the model but not hurt the decals.

And after a re-paint I want to use them again...

It's made from cartograf  and it has been apply for some times...

wondering if my idea can be realized?

thanks in advance :)

 

Share this post


Link to post
Share on other sites

You can try soaking it in water and see if it floats off.  Then use glue from the blank areas of decal sheets to restick it.  I actually did this successfully back in my early modeling days, but it was with a decal that had just been applied a few hours earlier.  

Share this post


Link to post
Share on other sites

Brett's idea sounds good, but I would suggest that if you are able to get the decals off in one piece you should scan them so that you could make new decals. This would also give you an extra set of decals that you could use for a team car or any thing else.

Share this post


Link to post
Share on other sites

You'll spend less time looking for another set. Almost impossible to impossible especially if they have been cleared over. 

Share this post


Link to post
Share on other sites

Many things that seem impossible turn out to be possible if you have enough time, talent, patience and skill.

However...I don't think this is one of them. B)

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...