• Announcements

    • Forum Posts, Moderating, Reporting, etc.   12/20/2016

      The Report function of the forum works well. If you see someone acting up, acting out, or just being an okole, use the Report function. It works! I have it set up so it not only sends me an email, but that email is then marked with a flag, and get's put to the top of my email list. I will try to access/look at the report/topic as soon as possible, but remember, I'm on a six hour time delay, and other mods not only have a life, but a real job as well.  k den
Sign in to follow this  
Followers 0

Modelhaus question

2 posts in this topic

Posted

I have the reissue of the AMT '63 Galaxie I am building, and there are HEAVY mold lines on the front and rear bumpers. I have no way of rechroming these bumpers after removing the mold lines, and it seems it would be just as cost effective to order them already chromed from Modelhaus as it would be to send mine out to Chrome-Tech for replating..

my question is this: will the chromes bumpers from the modelhaus have that mold seams removed before they were chromed??

Share this post


Link to post
Share on other sites

Posted (edited)

I have some Modelhaus 63 Bonneville bumpers, and they DO NOT have the mold lines removed, and you can even see where they were twisted from the sprue before casting(probably 40 years ago), can't say the same about their Galaxie bumpers though as I've never seen them. It might cost a bit more, but for my money I would set up a sprue per Chrometech's guidelines, load it up with cleaned up parts and send it out. Just my 2 cents, but I have lots of stuff I would like to get chromed too.

Edited by novadose71

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0