Jump to content
Model Cars Magazine Forum

Recommended Posts

Thanks guy. I’d like to see some other folks builds of this kit and see how they had dealt with the issues I had. There’s not a lot of these builds posted on line. 

Link to post
Share on other sites

I built this kit a few years back, put in a fuel-injected SBC.  For the hinge I used wire and brass tube. It made the hinging easier but didn't do a thing for the fit at the fender, therefore I display it with the front flipped forward.

5EJAlPW.jpg

RPwqeFT.jpg

Link to post
Share on other sites

I will be starting a build of this one soon.  I have a couple of questions now after going over the instructions and doing some test fitting. Is the box floor assembled above or below the guide pins on the box sides? It also isn't very clear about the gas tank mounting position. There seem to be a location marked on the frame in front of the radiator, but it doesn't fit with the 4 feet of the tank on the frame. Is that why yours is mounted the way we see it?

Link to post
Share on other sites
On 4/26/2021 at 6:37 PM, cobraman said:

Looks good. I was never able to get that tilt front end to fit right,

Welcome to the club! Mine was never correct either.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...