Sign in to follow this  
Followers 0

Revell 2009 Dodge Challenger SRT8. Help needed....

4 posts in this topic

Posted · Report post

Okay, at the point of installing the chassis to the body I have run into a HUGE problem with it seating properly in the front. I can't see where the inteference is coming from & the interior tub is securely glued into the body. But the front splash pan sticks out a mile below the chin spoiler. If I apply copious amounts of pressure it will line up, but I don't want to clamp the body & ruin the paint (black, of course)

Anybody run into this with this kit? Suggestions...?

TIA

Share this post


Link to post
Share on other sites

Posted · Report post

It sounds to me like you have the rear of the chassis above the license plate indent instead of below it.Try repositioning the chassis as you insert it into the body.

Share this post


Link to post
Share on other sites

Posted · Report post

I have built this kit...and had no problems of the such...Good Luck ;)

Share this post


Link to post
Share on other sites

Posted · Report post

Hi Mathias, The front splash pan should be installed after the chassis, unless that is how you did it anyway. This is infact how it is on the 1:1 car. We have a '10 Charger RT with allwheel drive. The bottom of this car is very smooth compared to most vehicles. But the front splash pan, which is a hard plastic, protects both the steering rack and the oil pan. Hope this helps.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0