• Announcements

    • Forum Posts, Moderating, Reporting, etc.   12/20/2016

      The Report function of the forum works well. If you see someone acting up, acting out, or just being an okole, use the Report function. It works! I have it set up so it not only sends me an email, but that email is then marked with a flag, and get's put to the top of my email list. I will try to access/look at the report/topic as soon as possible, but remember, I'm on a six hour time delay, and other mods not only have a life, but a real job as well.  k den

Jack stands

7 posts in this topic

Posted

I thought I would throw together a set of jack stands for fun today. I think they turned out ok and they work too!

DSCF3733.jpg

Share this post


Link to post
Share on other sites

Posted

how do you make them?????

Share this post


Link to post
Share on other sites

Posted

I used sheet styrene for the base, square tube for the upright with a smaller square tube to fit inside. For the top I just used c channel. The handles are paper clip cut and bent.

Share this post


Link to post
Share on other sites

Posted

Nice! I might give it a go and try to make some of these. Thanks for the tip.

Share this post


Link to post
Share on other sites

Posted

Nice idea. They look very good.

Share this post


Link to post
Share on other sites

Posted

Nice!

Did you drill holes into the inner upright square stock for adjustable height too?

Thanks for the tip

Share this post


Link to post
Share on other sites

Posted

Yes, I just drilled through both square rods at different heights so they are adjustable.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now