Easy radiator hoses

7 posts in this topic

Posted · Report post

So you swapped that big block into your '37 Ford, got the radiator in place, and then you came across a little problem: what are you going to do for radiator hoses? The stock ones obviously aren't going to fit, I suppose maybe you could try bending them out of sprue but what about when you have a bunch of tight bends to make?

The soloution: solder wrapped in black (or, any color if you're into that) heat shrink tubing.

Simply cut a piece of solder a little longer than you think you need- you can even mock up the new hose before hand then straighten it back out. Put the heat shrink tubing around it, shrink it, then bend it back to the shape you need.

Not only does it let you make hoses in whatever shape you need, it looks good too!

Share this post


Link to post
Share on other sites

Posted · Report post

And if you don't have any heat shrink tubing, just paint the "hose" flat black!

Share this post


Link to post
Share on other sites

Posted · Report post

This is a great thread.

I am just getting ready for a build, and wanted to make realistic looking hoses. Thank you!!!!!

Share this post


Link to post
Share on other sites

Posted · Report post

Another trick for hoses is solid(not stranded)-core wire with black jacketing, about the size of the kit hoses; cut the wire to length and strip about 1/16" of the coating on the ends....voila! locating pins.

Share this post


Link to post
Share on other sites

Posted · Report post

There is also another way. At Hobby Lobby in the jewelry making Department there is a product called Pony Bead lacing. It is a hollow black rubber about the size of most radiator hoses. I just use some plastic rod as pins to hold it in place. I used it on my 49 Merc that I did last year and one i just Finished last week. Here is the pic of the engine with it being used.

IMG_4028.jpg

Share this post


Link to post
Share on other sites

Posted · Report post

Another twist on this tip is. Strip the insulation (Appropriate diameter and Color) off of some wire and slide the solder into it, then bend and cut it to length. I've even used solder in the center of braided fuel line. Possibilities are endless..

Share this post


Link to post
Share on other sites

Posted · Report post

What Steve said, but use wire from large paper clips.

I find it easiest to shape the wire first then slide the insulation over the top.

And don't stop at black - colour code your hoses to match the paint...

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now