• Announcements

    • Forum Posts, Moderating, Reporting, etc.   12/20/2016

      The Report function of the forum works well. If you see someone acting up, acting out, or just being an okole, use the Report function. It works! I have it set up so it not only sends me an email, but that email is then marked with a flag, and get's put to the top of my email list. I will try to access/look at the report/topic as soon as possible, but remember, I'm on a six hour time delay, and other mods not only have a life, but a real job as well.  k den

Making lowered working suspension

6 posts in this topic

Posted (edited)

I need help with lowering suspension AND making the suspension work.

Edited by Kyle Krueger

Share this post


Link to post
Share on other sites

Posted

http://www.italianhorses.net/Tutorials/Shocks/coils.htm

You can start with this. Using less spring coil, would lower it. The Front of the car, would be my concern, because, unless it has separate lower control arms, you are going to have to cut, and hinge pin, to allow movement. Others may have suggestions, just getting you a starting point

Share this post


Link to post
Share on other sites

Posted

First, what is your skill level Kyle? What you are asking is seriously advanced modeling.

Share this post


Link to post
Share on other sites

Posted

And what kind of suspension under what kind of car? Kinda "working" leaf springs are fairly easy to do, but the independent suspensions do indeed require more advanced skills.

Share this post


Link to post
Share on other sites

Posted

First, what is your skill level Kyle? What you are asking is seriously advanced modeling.

I suppose that info would be important LOL. I'm not the most skilled person, but I'm fairly skilled

And what kind of suspension under what kind of car? Kinda "working" leaf springs are fairly easy to do, but the independent suspensions do indeed require more advanced skills.

http://manuals.hobbico.com/rmx/85-4254.pdf

This car right here..

Easy in the front for lowering, not sure about the back.. HELP?

Share this post


Link to post
Share on other sites

Posted

Nope the back is even easier. Create some brackets so that the front of part #22 can pivot where it joins the crossmember. Then just use some real springs in place of the plastic coil springs.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now