Jump to content
Model Cars Magazine Forum

Recommended Posts

This morning I had a thought and tried it out. I took a "flux brush" (for applying solder when sweating copper tubing) and trimmed the bristles down to about 1/4" long. This worked pretty well to burnish BMF into tight crevices. Its stiff, so you have to be careful with it. I'm sure it will scratch paint if leaned on to heavily.

post-12516-0-44153900-1396463427_thumb.j

Share this post


Link to post
Share on other sites

I've been using a Q-Tip, a toothpick, or the end of a paint brush handle to burnish my BMF and it works great for me.

Share this post


Link to post
Share on other sites

I have had good luck in the past with a Testors burnishing tool. Comes with different tips...

Share this post


Link to post
Share on other sites

Have any of you guys tried using this hvac tape I tried some tonight it worked OK but its kinda hard to cut so its tuff to make a clean straight cut

post-13580-0-05648500-1397212752_thumb.j

post-13580-0-97349100-1397212869_thumb.j

Share this post


Link to post
Share on other sites

I have used both and I prefer the BMF just easier to work with it will still drive you crazy but not nearly as crazy as with the flu tape

Share this post


Link to post
Share on other sites

I have used both and I prefer the BMF just easier to work with it will still drive you crazy but not nearly as crazy as with the flu tape

I agree with Dave, BMF is easier to use but I rarely foil much anymore.

Share this post


Link to post
Share on other sites

AD Lassiter makes a tremendous BMF burnishing tool. I'll try to get him to post it here.

Share this post


Link to post
Share on other sites

I wouldn't go near a painted model with an acid brush, especially one that has been cut down. I use them professionally where I work and they can be very aggressive to any finish. It's like washing a car with a bristle brush.

Share this post


Link to post
Share on other sites

How I do my BMF, cut and place on model, rub down on BMF with finger, use a cut down toothpick shaped to a flat-head-type shape and burnish that and then trim. After that I run a t-shirt or rag over the BMF to burnish it down more and sort-of polish it. I would be careful with the flux brush, you might scratch your paint or tear all the BMF off by accident..

Share this post


Link to post
Share on other sites

soft balsa wood makes a great burnisher.. conforms to the surface nicely

Edited by scalenut

Share this post


Link to post
Share on other sites

I use a pastel/chalk blending stick. It's soft yet firm and you can sharpen it to a point with a pencil sharpener to get down into tight crevises. Been using the same one for 20 years.

http://www.dickblick.com/products/loew-cornell-blending-stumps/?clickTracking=true&wmcp=pla&wmcid=items&wmckw=22866-1059&gclid=Cj0KEQjwvLGfBRDfkrr19KDS-7YBEiQA8CoFJz6P_XGwVWgfYKbZc2HW8F1VjSdcqDhXLD4tjpmVU5AaAqHp8P8HAQ

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...