68 camaro r2b2 chassis

19 posts in this topic

Posted · Report post

I started with a T.D.R 68 Camaro chassis and replaced a couple of bars and started installing 1/32 brass wire to support the fire bottles , co2 bottles , and a holder for a small battery for the computer

Share this post


Link to post
Share on other sites

Posted · Report post

Nice bro.

Share this post


Link to post
Share on other sites

Posted · Report post

thank you

Share this post


Link to post
Share on other sites

Posted · Report post

looks like you're off to a great start henry! i realize you're doing a '68 camaro but, have you decided on any of the drivetrain?

Share this post


Link to post
Share on other sites

Posted (edited) · Report post

going to be to the flash point 526 hemi along with a tdr mark Williams rear end and not sure on the transmission yet and I am using futurattraction dzus fastners and dirt modeler bracket and tabs along with micro nitro front and rear coil overs and struts along with the fire bottles

Edited by phantom1

Share this post


Link to post
Share on other sites

Posted · Report post

Looks good. I don't know why you would need me haha

Share this post


Link to post
Share on other sites

Posted · Report post

funny buddy

Share this post


Link to post
Share on other sites

Posted · Report post

Haha

Share this post


Link to post
Share on other sites

Posted · Report post

must be all that body work going to your head :lol:

Share this post


Link to post
Share on other sites

Posted · Report post

Looks good Henry....

Share this post


Link to post
Share on other sites

Posted · Report post

That looks fantastic, Henry!

Share this post


Link to post
Share on other sites

Posted · Report post

Looking good, Henry. Keep the updates coming.

Share this post


Link to post
Share on other sites

Posted · Report post

thank you all and scott has some great products that I am using on this build

Share this post


Link to post
Share on other sites

Posted · Report post

Henry - did you already cut it, so that you could get inside, or you haven't gotten to that point yet? Where would you make the cut, in order to not lose any strength in the chassis when it goes back together?

Nice looking right at the start. Good job.

Share this post


Link to post
Share on other sites

Posted · Report post

yes I did around where the seat would go then I glued in pieces of 3/32 tubing

Share this post


Link to post
Share on other sites

Posted · Report post

Phantom i know you got the chassis from TDR was it through shapeways? if so how do i get some ? thanks shaun.s.

Share this post


Link to post
Share on other sites

Posted · Report post

yes you can get it through shapeways just go over to tdr's web site and you can purchase one through trd or through teds modeling

Share this post


Link to post
Share on other sites

Posted · Report post

Henry.... you are off to a great start here. This is going to be a nice build. Looking forward to seeing more. What kind of engine you gonna do for this.

Shaun... you can also go straight to shapeways and search for TDR Innovations and their stuff should come up as well bit if you fo to TDRs page like henry mention it will take you to shapeways.

Share this post


Link to post
Share on other sites

Posted · Report post

I was thinking of going with a flash point 526 hemi

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now