TheCat Posted November 7, 2010 Posted November 7, 2010 Fourth Step: Drill a hole on the model kit at the location of the Radio Antenna. Fifth Step: When the Putty is hard enough, drill a hole so you can slide the Brass Rod through. Sixth Step: After you have drilled the hole in the Putty, cut the Putty to the desired length. Here’s the drilled Putty cut the length I wanted for this car kit. Seventh Step: Slide the Putty onto the Brass Rod. Eighth Step: Put a dip of Model Glue (I use Insta-Cure + Super Glue)
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now