[Post your Revell 1970 Cuda]

Here is a Cuda I built a few years ago.

[Model Car Garage PE 701/2 Baldwin Camaro Dash]

That's looking pretty good. Is this thread only for the dash??

I just started the Baldwin kit and thought I would share. The rest will come along later.

[Model Car Garage PE 701/2 Baldwin Camaro Dash]

I used the E6000 glue just in case I had to adjust the position. The E6000 stays abit soft, unlike using CA.

[Model Car Garage PE 701/2 Baldwin Camaro Dash]

Nice! This part install was challenging.

[Model Car Garage PE 701/2 Baldwin Camaro Dash]

I just started to build the AMT Baldwin Motion Camaro and have the MCG PE set for the car. The instructions are not clear on how to install the dash top. I came here and found some info on how to do it. Here are some pics on how I installed the dash top. I used the PE part as a template to cut the kit part, thinned the kit part to create the line for the pad then CA'd a small shelf to glue the PE part onto. It helped to roll a crown into the PE part that matched the dash before glueing the part with E6000 adhesive, I found this was more forgiving than CA.

[Greetings from the N.W.]

_Thanx,

_{I am currently building the Trumpeteer 1964 Falcon Sprint. I will post pics of the build.}

[Revell 68 Pontiac Firebird]

To combat dust during painting, get a cheap blow dryer with an anti frizz setting. This will ionize the plastic surface and help to keep off the dust. The ionizing removes the static charge from the plastic body.

[Greetings from the N.W.]

hey,

just found your forum, I have read the mag for years. I am an award winning car modeler with 30 plus years of "quality" building.

Darren