DoctorLarry Posted November 6 Share Posted November 6 Does anyone do Pontiac engines or Buick 350/455 engines in resin? Quote Link to comment Share on other sites More sharing options...
Texas_3D_Customs Posted November 7 Share Posted November 7 On 11/6/2024 at 9:39 AM, DoctorLarry said: Does anyone do Pontiac engines or Buick 350/455 engines in resin? I don't yet... Quote Link to comment Share on other sites More sharing options...
futurattraction Posted November 14 Share Posted November 14 I am working on a Pontiac engine. Not finished with it yet - mostly peripheral pieces to do. I am working on a tripower setup, but also intend to do a single 4V. I need to finish tri-pwr carbs, single 4V intake and carb, a manual trans (which one? preference? And I am planning to do a TH400. In the pics, below, everything shown was drawn in 3D except the valve covers, which are kit repops. 4 Quote Link to comment Share on other sites More sharing options...
Texas_3D_Customs Posted November 16 Share Posted November 16 Here's where I am at on mine 3 Quote Link to comment Share on other sites More sharing options...
Texas_3D_Customs Posted November 16 Share Posted November 16 More progress 1 Quote Link to comment Share on other sites More sharing options...
DoctorLarry Posted November 19 Author Share Posted November 19 Sweet! Thanks to both for making the attempt to do these. IT is much appreciated (at least by me). 1 Quote Link to comment Share on other sites More sharing options...
Texas_3D_Customs Posted November 23 Share Posted November 23 Done with the stock version 7 Quote Link to comment Share on other sites More sharing options...
DoctorLarry Posted November 29 Author Share Posted November 29 4 barrel intake yet? Quote Link to comment Share on other sites More sharing options...
Texas_3D_Customs Posted November 29 Share Posted November 29 4 hours ago, DoctorLarry said: 4 barrel intake yet? Yes it's on my thread Quote Link to comment Share on other sites More sharing options...
Ron Hamilton Posted November 30 Share Posted November 30 On 11/22/2024 at 8:10 PM, Texas_3D_Customs said: Done with the stock version Beautiful! Quote Link to comment Share on other sites More sharing options...
DoctorLarry Posted November 30 Author Share Posted November 30 3 hours ago, Texas_3D_Customs said: Yes it's on my thread I saw it on the web site. Order forthcoming Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.