4knflyin Posted December 20, 2024 Posted December 20, 2024 (edited) I'm doing a Tamiya 1:24 Porsche 959 build, and somehow I got the impression from a 959 WIP that these windows need to be painted on the outside. So I did that... without checking again in other 959 build threads. Did I make a mistake? (Man, this build is full of mistakes, another isn't going to send me screaming.) If on the inside, how then is the front window attached? Where are the glue points? I'm inclined to think they're OK, but I would like your honest opinion (and an explanation would be helpful). Since they're exposed, I sealed them with a few coats of clear and so far, so good after too many drops. Here's where they are now (not glued): An extra qu. on the front. That horrible mark from where it was attached to the sprue happened even though I used a very sharp pair of knips. It made that scrunching sound as I cut it. Is there a way to remove those types of things? Thanks! Edited December 20, 2024 by 4knflyin
rattle can man Posted December 20, 2024 Posted December 20, 2024 If it si outside trim/ gasket on the 1:1. then I would paint the outside to get the correct sheen/ gloss 1
Mark Posted December 20, 2024 Posted December 20, 2024 Rubber edge trim should be painted on the exterior surface. Tint would be applied to the interior surface. 1 1
peteski Posted December 20, 2024 Posted December 20, 2024 (edited) Yes, you did this correctly. What you painted is the trim/gaskets. However, most contemporary cars also have the windshield and rear window perimeter area painted on the inside - check your own car to see that. And if you are tinting the windows that is also best done from the inside. Edited December 20, 2024 by peteski 1
NOBLNG Posted December 20, 2024 Posted December 20, 2024 (edited) In my experience, when removing clear parts from the sprue, it’s best to use a saw to cut the sprue close to the attachment point. Then use a file or sanding stick to remove the remainder. Using nippers risks cracking the plastic since clear parts are more brittle than regular styrene. Edited December 20, 2024 by NOBLNG 5 1
Ulf Posted December 20, 2024 Posted December 20, 2024 You have done a fantastic job getting the windshield on this car, that is an achievement in itself. Sometimes white lines on clear parts can be less visible if you paint the edge black or silver but that said sometimes. 1
4knflyin Posted December 21, 2024 Author Posted December 21, 2024 (edited) Your feedback is gratefully appreciated. Onward. I should add that this my first "closed cockpit" car model, hence my discomfort. Edited December 21, 2024 by 4knflyin
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now