Repair before airbrushing molotow

[johnyrotten]

I'M looking for some advice with this. Two of the headlight bezels on my kit have "chips" where they have come off the sprue. no, I didn't rip them off the tree, old kit, rough handling over the years I suppose🤷. Anyway, I'm not sure putty will do the trick, very small spot,and thin. And being a different material, it would probably ghost through the molotow.  I'm kinda thinking of gluing a small piece of styrene and reshaping. Am I thinking in the right direction here?

[sidcharles]

either Bob Smith Industries  ic 2000 black cyanoacrylate adhesive or Mr Surfacer (Mr Hobby) 1000 have worked for me under like conditions.

IC-2000 | Rubber-toughened CA

cleans up with debonder or sanding sponge

CA Debonder | Un-Cure

Mr. Surfacer 1000 - Mr. Hobby

sanding sponge

both take a bit of time to dry

apply with toothpick

i've had some success with both

if you search through some of Night Shift videos, he uses it extensively   (6) Night Shift - YouTube

Edited June 29 by sidcharles