Humidity

[Acarnut2]

I was wondering.... I was painting today and my airbrush kept on clogging even after consecutive cleanings. I was using Evercoat Feather Fill Primier through my airbrush and I kept on getting into jams. First the paint was tooo thick and was drying before it hit the surface of the car. The specs on the paint say not to thin the primer. Since I kept on getting jams I first reduced it with a few drops of reducer. Got the same affect until I decided to add thinner. It would then spray well for a few seconds then the setiment in the aribrush cup would jam the gun. THe primer got so thin that it started to craze on the car.

What I would like to know is did a 70% humid day play a part in this disastorous paint session? tHANKS....AL.

[MikeMc]

I would doubt it....sounds like either not thin enough or pressure too low. Humidity will cause a blushing....not spitting and sputtering

[doublejuggs]

I would agree, wack the psi right up and see if you get the same problem. thats easier and quicker to rule out than trying all different paint mixes.