Fuel Block Lines for Blowers / Injectors

[Nitrozilla]

Recently I tried to make a jig to form solid wire fuel lines for blowers and injectors. It was less than successful. Biggest part of the problem is unbending the pre-bent line to put it thru the fuel block, then reshaping it to insert into the holes on the blower / injector.

Should I just do one line for each one instead of my current method ??

Any help would be good.

[Mike Kucaba]

I don't understand the "pre-bent" part of this.If the wire is kinked off the roll,just pull it around the handle of your hobby knife. I guess a Pic would help.