Easy brake rotors out of Stainless steel washers

[Kennyboy]

I created these brake rotors for my 1/12 GT500 out of 1 1/4" washers at local home store (Menards)

Put a bolt thru the washer, put a nut on it, and put it in the drill. While i spun it with the drill I ran a sharp screwdriver

over the surface to create the machined look of a rotor. The caliper was made out of nylon 1 1/4" washers that were stacked

and glued and then cut out and machined with a Dremel tool. Because there are many different sizes of washers out there you

could use this tip for virtually any size model. Cost was about $3.00 or so.

[lazlow]

thanks, great tip, looks spot on. and if a guy (not me) wanted to they could cross drill, the big ones.

[MikeyB08]

That looks great!!! How you machined the caliper using a Dremel is beyond me. Great tip!

[vintagercr]

Great tip!

[CrazyGirl]

super cool tip , I'll use this one !!

[Kennyboy]

Thanks guys (and girl) I will be happy to share any knowledge with you in the future.