Search the Community
Showing results for tags 'muffler'.
-
I recently made these mufflers and thought I would share the process. First I glued two pieces of .156β tube together and filled the crotch with some half-round and CA. Then I sanded the ends square and capped them with some thin styrene sheet. Sand the end caps flush and drill the holes for the .100β exhaust pipes....simple!π The tubing allows the exhaust pipes to βfloatβ in and out a bit until everything is in place so it can be glued solid. The exhaust pipe can be solid styrene, solder, or in this case I used .100β tube with some soft wire shoved inside.