stevekouw Posted September 7, 2012 Share Posted September 7, 2012 I thought I would throw together a set of jack stands for fun today. I think they turned out ok and they work too! Quote Link to comment Share on other sites More sharing options...
c-man405 Posted September 7, 2012 Share Posted September 7, 2012 how do you make them????? Quote Link to comment Share on other sites More sharing options...
stevekouw Posted September 7, 2012 Author Share Posted September 7, 2012 I used sheet styrene for the base, square tube for the upright with a smaller square tube to fit inside. For the top I just used c channel. The handles are paper clip cut and bent. Quote Link to comment Share on other sites More sharing options...
rmvw guy Posted September 7, 2012 Share Posted September 7, 2012 Nice! I might give it a go and try to make some of these. Thanks for the tip. Quote Link to comment Share on other sites More sharing options...
cobraman Posted September 9, 2012 Share Posted September 9, 2012 Nice idea. They look very good. Quote Link to comment Share on other sites More sharing options...
Edward Gore Posted September 9, 2012 Share Posted September 9, 2012 Nice! Did you drill holes into the inner upright square stock for adjustable height too? Thanks for the tip Quote Link to comment Share on other sites More sharing options...
stevekouw Posted September 9, 2012 Author Share Posted September 9, 2012 Yes, I just drilled through both square rods at different heights so they are adjustable. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.