obs.caleb

I got it to work now i don't know what the problem was.

What are day 2 mods?

What kit are you starting with?

I did some research and i think your best choice is to use the 5.3 there are tons of these and you can find them in good detail.

which motor are you going to use for that build?

I just looked at the escalade kit and yall were right it is a much better starting point than trying to scratchbuild the parts. Thank you for the advice everyone.

Not a very good picture but I saw this beauty of an automobile

Are you going to start a build thread for your sierra?

I was taking them from the camera.

I agree as I have bought many wheels from him.

That's a reply I like. I'm probably not going to finish it.

Update: Jay's resin wheels said he could print the wheels in that size I was somewhat surprised he could do that so thank you for the idea

I have built the tahoe kit and it's just not at the level of detail and accuracy I'm going for. Right now I have a mostly correct front axle and transfer case, driveshaft but I might have to scratch build some parts. If someone could supply pictured of the 4wd spindles I would appreciate that. Right now I'm building the skids and torsion bars and mounts. My problem is the cv axles and control arms if I could get some advice on scratch building those that'd be good.

I was trying to take a photo and insert into my post but it kept saying editor has been restored every time I tried to put the photo in why was this happening?

I'm working on a 98 k1500 and am trying to build an accurate 4x4 front suspension here Is what I'm working with

Did some more chassis work and my knife slipped and cut in between my pointer and middle finger. The cut was close to a half inch deep.😬

Thank you I will try that.

UPDATE: there are 24 inch snowflakes but they are 50 DOLLARS!!!!!? That is ridiculous for model car wheels.

I am currently working on a 98 k1500 and am doing a replica of a certain truck. The truck I’m building features 24 inch wheels (I know bring on the hate) and are gm snowflake wheels. On the market there are both 26s and 20s but not a 24 what should I do about this?

Woah getting a little destructive there. I’m still figuring out what I’m going to do. I’ve got other projects to think about. I’m probably going to get a new body and start over.

Got the front end of the frame finished. Still have to sand the glue.

I did some work on the chassis and shot some primer on the body and hood.

What's going on with the cab?! There isn't any panel lines?!

Got the extended cab kit in the mail today started on the body work. First thing I did was remove the mounting pins from the inner fenders.

After years I finally restocked on glue and knife blades. I got a few other things too...