Ira

Great Start Jeff!

2085 VETTE JET! The Vette Jet will be a Futuristic Flying Car with Tandem Seating. I started Vette Jet a while ago. I have been working on it between other builds, until now. Now, I am going to try to finish the Vette Jet in time for NNL WEST on February 1, 2014. I will be using parts from 2 Monogram 8th scale 1985 Corvette Kits and a 12' long MPC X-Wing Fighter. I bought one of the Vettes on Ebay for about $20 and then I received a second Corvette body in a trade. Both Vette bodies were warped and the tops were also broken. This should be Fun, lets get started! More Coming....

Thanks Carl!

Thanks Ray!

Thanks Jay!

Great T's Terry! Thanks for Sharing...

Great Build Jim!

Looks Great Jim!

Thank You Dr.!

JUST A FEW MORE... That's All Folks! Hope you enjoyed the Tie X-Wing Interceptor...

Thanks!

MORE FINISHED PHOTOS! More Photos Coming...

TIE X-WING INTERCEPTOR IS FINISHED! The Interceptor was made with left over parts from the Jedi Tie Wing Racer. Its just under 6 inches long. The X-Wings were modified so the engines are on the outsides of the Wings. The Tie Wing Supports were removed from the Tie Wing Cockpit and the main body was from another X-Wing kit. Here are some Finished Photos! More Finished Photos Coming...

Great Build! Funny Idea...

A FEW MORE... That's All Folks! Hope you enjoyed the Jedi Tie Wing Racer...

Great Painting Bobby! Nice Tires too, are they modified Deals Wheels?...

MORE RACER PHOTOS! A Few More Coming...

JEDI TIE WING RACER IS FINISHED! The Racer was built from parts from the X-Wing Fighter, the Tie Wing Interceptor and the B-Wing Fighter Kits. The original idea was to make a Streamlined, Long Distance Racer. I actually increased the length of the Star Racer from 7 inches to 10 inches long. With the leftover parts from this project I built another Starship, The Tie X-Wing Interceptor, Check it out In this Forum! Side View. The Hyperdrive Rhinestones look like lights in this shot. More Photos Coming...

Thanks Adam!

UP IN THE AIR! I drilled a hole in a wooden base and glued a length of Clear Acrylic Rod in it. Here are a few progress shots with the Viper on the Rod... More Coming...

Looks Great!

CLEAR SUPPORT! I am going to use a length of Clear Acrylic Rod to support the Viper in the flying position. I started by drilling a hole in the bottom, large enough to fit a length of Plastic Tubing, for the Clear Rod to slide into. Next I applied glue on the end of the tubing and slid it in place. I applied a little Zap-A-Gap Glue around where the tube fits into the body. Then I cut off the Tubing flush with the Engines. More Coming...

BLENDING IT IN! I cut a piece of plastic to fit between the X-Wing and the Viper Bodies. After a little sanding and fitting I glued it in place. Next I cut and fit a couple more plastic pieces and glued them in place. More Coming...

Thanks Carl!

NEW FINISHED PHOTOS! I like it better without the Landing Gear. Thanks Hobby Bobby! That's All Folks!