Ira

LOOKS GREAT CURT!

Very Clean Build!

Thanks Dan!

Great Progress!

BRACING UP THE BODY! I measured and cut some plastic strips for Body Braces. I glued in one on each side to the '57 Body. Then I glued in two more strips, one on each side. These braces will hold the Z-28 body sides straight. More Coming...

GREAT START!

THE WINDSHIELD IS CRACKED! The Attempt Body was from a built up kit from Ebay. The Windshield was cracked, so I glued it in and started sanding... Added a little Squadron Putty... After a little more Sanding and some Primer, here is the new Windshield compared to the original! I will mask the windshield area and spray it Gloss Black. Here is a Mock-Up on the body. More Coming...

Thanks Dave!

Thanks Albie!

Thanks Bruce!

Thanks Mike!

Thanks Bob!

THE REAR END! I cut a piece of sheet plastic to fit between the rear fenders, for a New Roll Pan. Then I glued it in place. The bottom edge of the body was a little rough, so I marked a straight line above the problem area... I cut along the line with a Cut-Off Wheel in the Dremel Tool. Then I cut a length of plastic strip to fit and glued it in place! More Coming...

PULL IT IN! The Z-28 sides stick out too much at the front/bottom... I cut along the seam and moved the front panels in closer! More Coming...

Thanks Chris! Yeah, you should try a Deals Wheels Kit, they are Great Fun...

Great Start!

FUTURAY IS FINISHED! Here are a few Photos! Side View! Nice Pipes... Rear View! Check out all of the Futuray Finished Photos in the "All The Rest" section...

Thanks Codie!

Thanks Dominik! So glad you like it...

Thanks Rob!

Thanks for the kind words Jairus! I put in the link to the WIP Photos...

A FEW MORE... Front Top View... Rear Side View! Rear Under View! That's All Folks! Hope you like the Futuray...

Thanks Al!

Thanks Carl!

Thanks Chuck!