Matt McNally

Thanks for the comments every one. Here are some more shots of the car. This is a typical build for me, pretty much out of the box with paint detailing to match reference shots for the engine and interior with some roll bar padding added. Tire lettering is decal, either from old Monogram decal sheets or after market sheets. Matt McNally

Here's another version of a Buick that Mark Martin drove in 1983. Very similar to the JD Stacy car with Valvring as the main sponsor. This particular car ran with the chrome 5 hole rims, he also ran the same sponsor on a Buick with body colored rims. Monogram kit with Wetworks decals. Here's the reference shot I used for this build: and here's a shot of the JD Stacy car along with the Valvring car: Matt McNally

Thanks. There are some more photos on my web site, just click on the photo on the homepage. http://www.mnacreations.com/Models/ If you want some shots of the chassis, interior, or motor let me know and I'll take a few and post those as well. Matt McNally

This is the JD Stacy Buick that Mark Martin drove in a handful of races in 1983. Built from a Monogram Buick kit and Wetworks decals. Here's the reference shot I used for the build: Matt McNally

Got my 2nd Sta Power Torino finished this past weekend. This one was piloted by Bobby Isaac and is built from a MK kit,PPP wheels and tires, and Powerslide decals. Here's a shot of the Waltrip and Isaac Sta Power cars... Matt McNally

Got this one finished yesterday. Straight forward build from the MK Torino kit using Powerslide decals and PPP wheels and tires. Matt McNally

Thanks everyone. To get the wheels pushed out toward the fenders I ended up removing the raised center section of the inner rim. I cut a chunk of plastic tube that was large enough to slide over the end of the axle housing and attached that to the inner rim. Once that was set I trimmed it until the wheel fit inside of the fender where I wanted it. The only other thing to mention is that I attached the new mount off center on the inner rim so I could drop the rear of the car. Matt McNally

Here's Buddy Baker's RC Cola Torino that I managed to finish last night. Built with Powerslide decals on a Model King Torino with PPP wheels and tires. Matt McNally