‘55 Ford Customline stock version

[cpspoogie]

Well this is a real head scratcher.  No plastic kits made, resin bodies available.  I thought about taking this kit and “fixing” it by un-chopping the top, making the trunk normal with no spoiler, fixing the rear wheel openings, etc...then I realized this kit is a Crown Vic drag version.  I’m thinking to try it anyway and change the slanted pillar and all.  Any other ideas?

[John Goschke]

I thought Hendrix Resin did this in, well, resin...  http://www.resinrealm.net/Star/HendrixGallery/index.html

[espo]

This sounds like a very ambitious project. While doable there are many easier was to get were you want to be. If it's a Customline two door your after the resin kit might be the best starting place. If you want a '56 Crown Victoria AMT offers a kit of that and you can make it a standard Victoria or a Crown and even has the forward glass roof panel. I don't think the 1:1 Drag car you're looking at was based on a real car, it was a fiberglass   creation from the start.   

[cpspoogie]

15 hours ago, John Goschke said:

I thought Hendrix Resin did this in, well, resin...  http://www.resinrealm.net/Star/HendrixGallery/index.html

I since found this very listing.  That’s the route I’m going.  Thanks!