suspension

[evilone]

i need help with dropping my 55 cameo

it has leaf springs and im tryin to make it look as real as possable

its a shop truck that drops of parts and its a lowrider at the same time

any help would be useful

and no im not going to do air bags or hydros

[george 53]

Kev, just put lowering blocks on the rear end.they go between the rear axle an the springs the longer they are the lower the rear will sit. On the front, just do the same if its leaf sprung. If not, just cut the spindle shaft off, an move it up on the spindle, the higher you put it ,the lower the front end will sit.

[evilone]

Kev, just put lowering blocks on the rear end.they go between the rear axle an the springs the longer they are the lower the rear will sit. On the front, just do the same if its leaf sprung. If not, just cut the spindle shaft off, an move it up on the spindle, the higher you put it ,the lower the front end will sit.

the springs sit on top of the axles

and if i put them ontop of the springs they will look retarded

[CAL]

the springs sit on top of the axles

and if i put them ontop of the springs they will look retarded

Nah it wont. most car springs sit below the axe.

[evilone]

i fixed my problem thanks anyways

[evilone]

just out of pure morbid curiosity..........how??

i cut the leaves where the axles connected and glued the leaves to the axles

getto i know but hay i build good stuff while its juryrigged