Been away for awhile, but found an awesome Mustang model that gonna get a lot of TLC!

[DREAMSCALE CONCEPTS]

Hey guys! I’ve been away from the table just enjoying the summer sunshine outside and making model car purchases online and at swap meets. I came across a built model car called “The Monroe Handler “ Mustang that was built, missing parts and extremely dusty. I know that this kit was rare as the Monroe Handler and was released under other platforms by Revell. I haven’t seen any other kits like this one built before so I thought I would give it a try. I dismantled the car as best as I could and began to mock up my ideas for this car. I ordered Eleanor wheel and tires from Jays resins and a twin turbo coyote engine from iceman collections. 
I have cut out the rear floor pan so the car will sit lower for starters. I’m kinda short on time because of home renovations but will try to get some bench time day to day . Tell me what you think about this concept! 
enjoy your day!

[Bullybeef]

I like where this is heading, the body kit makes the old Mustang II look less like a pinto! 

[DREAMSCALE CONCEPTS]

10 minutes ago, Bullybeef said:

I like where this is heading, the body kit makes the old Mustang II look less like a pinto! 

The body kit definitely sets it off! 

[rv1963]

I like it a lot looks good low with those big wheels.

[Rdkingjay]

Very cool to see another one. I'm actually working on the same kit, but doing a whole chassis, suspension and interior swap from an AMT '88 Mustang. I've dubbed the project the RE-Handler. The thread is in this WIP forum. I'm very anxious to see the direction you take with yours!