NHRA Stock Eliminator '69 Nova

[Hemifever]

Engine done, moving on to interior and suspension.

[Hemifever]

Cal Tracs are next. Plan on removing the rear mounts and pivot plates, clean them up and using them on the Nova leaf springs, which will be sanded down to a mono leaf. Transfer link and hardware will made up of RB Motion items. More to come.

[keviiin86]

3 hours ago, Hemifever said:

Cal Tracs are next. Plan on removing the rear mounts and pivot plates, clean them up and using them on the Nova leaf springs, which will be sanded down to a mono leaf. Transfer link and hardware will made up of RB Motion items. More to come.

Great looking engine in the previous post! Its too bad that stock eliminator cars are forced to use stock intakes and carbs..cause a painted iron intake and quadrajet usually isnt what you think of when you think "performance" lol.  Where did you get those caltrac bars with leaf springs?  I bought some a few years ago from Ron Olsen when shapeways was still a thing..unfortunately I havent seen anyone else offer these from the aftermarket 3D printing world.

[Hemifever]

Cal Tracs are from MCV Products.

[Andrew McD]

Beautifully detailed engine!  Looking forward to seeing more of this project.

[Hemifever]

I got the leaf springs sanded down. Surgery on Cal Tracs next,. Also I have to get tire and wheel combo picked out.

[Hemifever]

Got the pivot plates and rear mounts off. Going to clean everything a little bit more for a better fit.