kizzy Posted February 8, 2011 Share Posted February 8, 2011 can any one tell me how to make the highlighted piece Quote Link to comment Share on other sites More sharing options...
High octane Posted February 8, 2011 Share Posted February 8, 2011 Kenneth, It looks like the front mounting plate for the engine and can be make with Evergreen or Plastruct plastic stock about 0.020 if I not mistaken. I hope this helps. Quote Link to comment Share on other sites More sharing options...
kizzy Posted February 8, 2011 Author Share Posted February 8, 2011 its the thing the hoses are going in to Quote Link to comment Share on other sites More sharing options...
SuperStockAndy Posted February 8, 2011 Share Posted February 8, 2011 The fuel block? It looks pretty simple to make with sheet styrene. You should also drill holes where the fuel lines go to hold them in better. Hope this helps Quote Link to comment Share on other sites More sharing options...
kizzy Posted February 8, 2011 Author Share Posted February 8, 2011 thx a bunch andy Quote Link to comment Share on other sites More sharing options...
brett Posted February 8, 2011 Share Posted February 8, 2011 Kenneth ,check out my buildups here http://smg.photobucket.com/albums/v392/awesome55/doorslammers/works%20in%20progress/ not so much nitrous stuff (but one on the bench at the moment), but a bit of stuff that might help you out. Quote Link to comment Share on other sites More sharing options...
Dom87SS Posted February 8, 2011 Share Posted February 8, 2011 for the fuel block get a piece of square tube styrene and a piece of styrene rod and cut each to length. cap off the box ends with sheet styrene and glue the rod piece to one end of it. attach those "fittings" to it and your done. Quote Link to comment Share on other sites More sharing options...
SuperStockAndy Posted February 8, 2011 Share Posted February 8, 2011 Wow, Dave, everyone has been asking how you do your engines! Quote Link to comment Share on other sites More sharing options...
kizzy Posted February 8, 2011 Author Share Posted February 8, 2011 thx a bunch guys and thx bret i got e mails a while ago from u for the nitrous lines Quote Link to comment Share on other sites More sharing options...
camarobuilder Posted February 8, 2011 Share Posted February 8, 2011 If you don't want to fab one up, Pro tech has afuel distribution block ,which has molded on fittings. While you're on their site, I would highly pecommend many of their other products. My link Frank Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.