Jump to content
Model Cars Magazine Forum

Recommended Posts

Posted (edited)

We're creeping closer to completion of the "Bad Brit" ........... into the stage of finding out which of our great ideas don't really fit or line up exactly as we had planned

Wiring, wiring, wiring ..........

110301thames01.jpg

110301thames02.jpg

110301thames03.jpg

Since we have decided for an "old" style hot rod, we have some extra things to accomplish ........... correct speedo gear for the tranny (since we are using an old style speedo rather than an electronic) ........ oil pressure line for non-electronic gauge, etc., etc. ........... steering has all been re-installed and adjustments made for proper handling

110301thames04.jpg

110301thames05.jpg

Edited by Old Coyote
Posted (edited)

Fiberglas Trends nose has been mounted and semi-positioned ......... positioning straps have been fabricated and installed .......... back side of nose has been sprayed with Dynamat

110301thames07.jpg

110301thames08.jpg

Grills have all been attached and lined up ............ all lights have been mounted, wired, and tested .......... the headlights have not been adjusted yet ........ that won't happen until everything is shimmed into proper alignment

110301thames15.jpg

110301thames12.jpg

110301thames14.jpg

Final adjustments have been made to the interior panels ......... only the header panel above the windshield remains to be fabricated and painted

110301thames13.jpg

020111thames09.jpg

We still have some problem areas which we will be adressing this week ......... the left door continues to hit the door jamb ......... Josh will remove the hinges and modify them to allow for more adjustment ..... that means the hinges will have to be repainted ............ the windshield and door glass will be installed and the urethane will be allowed to cure for 48 hours ........... then the gauges can all be hooked up and the dash installed .......... I am going to have to install a new pan gasket on the Turbo-Hydro 350 as it has started leaking (will do a rubber gasket this time instead of a cork) ........... still have to install the drop-down license plate holder ........... adjust all the door fasteners and pole braces ......... the final assembly check list is five typewritten pages long ............ but hopefully we'll be through this month ;)B):blink:

Edited by Old Coyote

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...