1/16 scale Pro Tech part

[Pro Tech]

Hey guys, just thought I would put another one of my 1/16 parts up for display.

1/16 Roll Bar Padding

Thanks,

Charlie

Pro Tech

http://protechmodelparts.com/16scalecatalog.htm

[Dr. Cranky]

Charlie, do you have those in 1/24th scale?

[MicroNitro]

That is really cool. Is it soft like the real padding? I take it I will need to slice it and then just slip it over the roll cage tube. Next you need to come up with 1/25 and 1/16 racers tape.

[Prostreet]

Nice Charlie, I really need to get an order into you sometime soon.

[Rdkingjay]

Another winner Charlie, thanks. I am putting together part #'s now for the wifey to order for me for christmas. Parts for my 1/16th dukes charger. BTW my profile pic of the hemi engine has one of your distributer/wire/wire boot kits on it. Best I've used in a long time.

Here's another angle.

Edited November 29, 2011 by Rdkingjay

[Pro Tech]

Charlie, do you have those in 1/24th scale?

Hey DC, of course we do . Part #PTMC 71, link below.

http://protechmodelparts.com/carpartscatalog4.htm

Thanks,

Charlie

Pro Tech

[Pro Tech]

That is really cool. Is it soft like the real padding? I take it I will need to slice it and then just slip it over the roll cage tube. Next you need to come up with 1/25 and 1/16 racers tape.

Hey Jim, yes, you need to slice one side (a brand new X-Acto blade for the straightest cut) then slip over roll cage tube. This product is not as soft as the real thing but does have the correct thickness as opposed to using heat shrink tubing which does not.

Thanks,

Charlie

Pro Tech

[Pro Tech]

Another winner Charlie, thanks. I am putting together part #'s now for the wifey to order for me for christmas. Parts for my 1/16th dukes charger. BTW my profile pic of the hemi engine has one of your distributer/wire/wire boot kits on it. Best I've used in a long time.

Here's another angle.

Hi Jay, thanks for your continued support and nice job on the hemi, look forward to your 1/16 build. I also have a 1/16 distributor kit (same basic design as the 1/25) in the works and will be out before too long.

Thanks again,

Charlie

Pro Tech

[Pro Tech]

Nice Charlie, I really need to get an order into you sometime soon.

Thanks Joe, yes I agree, get that order in real soon the part are calling your name, listen......... Joe, Joe, Joe, Joe, Joe........hahaha

Charlie

Pro Tech

[MicroNitro]

Hey Jim, yes, you need to slice one side (a brand new X-Acto blade for the straightest cut) then slip over roll cage tube. This product is not as soft as the real thing but does have the correct thickness as opposed to using heat shrink tubing which does not.

Thanks,

Charlie

Pro Tech

Thanks I will put an order together in the next few days.