34' Ford Hot Rod

[Rusty Sierra]

Hey guys,

I'm new here, but won't start with the pleasantries... Here's my 34' ford snap kit with an engine from a dragster snap skit (think it was the mad magazine one). So without further adieu... (I think that's how it's spelled)

Snap kit built according to instructions.

making the cuts....

Rear tires and rims from the same dragster kit and fronts are from some nascar snap kit I had laying around.

I cut small notches out for the belt due to the fact that I wanted to maintain the original screw holes for easy assembly. It just so happens that the plastic bit the screw goes into is right at the front of the engine in between the belt.

Next step is figuring out the interior. I just kinda eyeballed the entire project.

Keep in mind this is more of just a fantasy build, I'm not looking to get into plumbing, and insane amounts of wiring like some guys on this forum are... but any advice would be helpful as I don't think I've ever cut into a model before...

Thanks for looking.

[DANB]

that motors massive haha