PE Linkage for carbs

[John Pol]

When you guys use photo etch for your linkage on carbs. What kind of glue do you guys use and do put a guied pin to lineup the linkage arm to the carb. and also what size wire do you guys use for the linkage. If you can show its done that would even be better. And what is the linkage arms out there.

John Pol

[Dr. Cranky]

John, I use clear enamel. A little goes a long ways. I also tend to use watch parts for my linkages.

[John Pol]

Do you also install a guide pin for the linkage to the carb? And what size wire do you use for the linkage

John

[Austin T]

Future works good for PE and you have plenty of time to set things up right.

[jdmfan]

  On 4/4/2012 at 5:44 PM, John Pol said:

Do you also install a guide pin for the linkage to the carb? And what size wire do you use for the linkage

John

I use 26 28 30 gauge beading wire from micheals wire for carb linkage . Just depends on the hole that in the linkage your going to use .