blackbeard Posted April 9, 2014 Posted April 9, 2014 I started with a T.D.R 68 Camaro chassis and replaced a couple of bars and started installing 1/32 brass wire to support the fire bottles , co2 bottles , and a holder for a small battery for the computer
comp1839 Posted April 10, 2014 Posted April 10, 2014 looks like you're off to a great start henry! i realize you're doing a '68 camaro but, have you decided on any of the drivetrain?
blackbeard Posted April 10, 2014 Author Posted April 10, 2014 (edited) going to be to the flash point 526 hemi along with a tdr mark Williams rear end and not sure on the transmission yet and I am using futurattraction dzus fastners and dirt modeler bracket and tabs along with micro nitro front and rear coil overs and struts along with the fire bottles Edited April 10, 2014 by phantom1
goodwin3224 Posted April 10, 2014 Posted April 10, 2014 Looks good. I don't know why you would need me haha
blackbeard Posted April 10, 2014 Author Posted April 10, 2014 must be all that body work going to your head
blackbeard Posted April 10, 2014 Author Posted April 10, 2014 thank you all and scott has some great products that I am using on this build
TedsModeling Posted April 10, 2014 Posted April 10, 2014 Henry - did you already cut it, so that you could get inside, or you haven't gotten to that point yet? Where would you make the cut, in order to not lose any strength in the chassis when it goes back together? Nice looking right at the start. Good job.
blackbeard Posted April 10, 2014 Author Posted April 10, 2014 yes I did around where the seat would go then I glued in pieces of 3/32 tubing
superbike-shaun Posted April 11, 2014 Posted April 11, 2014 Phantom i know you got the chassis from TDR was it through shapeways? if so how do i get some ? thanks shaun.s.
blackbeard Posted April 11, 2014 Author Posted April 11, 2014 yes you can get it through shapeways just go over to tdr's web site and you can purchase one through trd or through teds modeling
Mooneyzs Posted April 17, 2014 Posted April 17, 2014 Henry.... you are off to a great start here. This is going to be a nice build. Looking forward to seeing more. What kind of engine you gonna do for this. Shaun... you can also go straight to shapeways and search for TDR Innovations and their stuff should come up as well bit if you fo to TDRs page like henry mention it will take you to shapeways.
blackbeard Posted April 17, 2014 Author Posted April 17, 2014 I was thinking of going with a flash point 526 hemi
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now