1/16? Chassis

[1/24DragAndStreetCars]

Here's my chassis! Anyone know where to get a 1/16 Hemi? Here's my hand for comparison

Would this be bigger than 1/16? like 1/12? I just wanted to start a big one

[Mike Kucaba]

Duke's of Hazard has the hemi. might be able to use the chassis and other stuff too.

[1/24DragAndStreetCars]

How much is the whole kit? Also guys I need a drag racing 8 3/4 axle or a Dana 60

[Mike Kucaba]

Check ebay?

[Mooneyzs]

Depending on what you are looking for you can get Hemi's in Resin, 3D printed or from a few kits. If you go the Resin Route Mark Johnson makes the best resin engines around. He had a 392 and 426 Hemi. you can take a look at my Funny Car thread to see the 426 Hemi of his that I am using for my funny car. The 3D hemi from TDR/Shapeways is going to be more expensive than the resin. You could always use an engine from either a 1/16 funny car or Dragster as well.

[Bonekrosha]

Easy way, get a 40% off coupon off line for Hobby Lobby, and go get a 1/16th Dukes or Super Charger kit.

Awesome way, get a Mark Johnson hemi, amazing.

You will still need the Dukes kit for an 8 3/4 rear end.