Mc Nasty 55

[Muskiebrains]

Just a quick mock up I'm stuck on how to slam the front end

[vintagedragcrazy]

Cool that's going to pretty bad when your done

Vince

[Truck parts]

Looking good

[tubbs]

Just a quick mock up I'm stuck on how to slam the front end

an easy way is to put a small strip of styrene at the bottom of the front air dam to get it "lower". otherwise, you have to move the pin that goes into the front wheel higher on the spindle to drop the front end, then you may have header clearance problems. you could trim a tiny bit off the top of the firewall, or wherever the body makes contact to the chassis. just watch whatever you do, may effect other clearances.

[Muskiebrains]

Thanks tubbs

[Muskiebrains]

Decided to cut the springs worked better than expected