Matt Bacon Posted May 9, 2012 Share Posted May 9, 2012 I'm talking here about those real metal foil transfers that are typically used for small chrome details and badges. I had no end of trouble with the ones in my Tamiya DBS kit, with them not sticking or lifting paint (on the engine cover). Previously I'd used a sheet of aftermarket Ferrari logos with no issues, but this is how I finally solved the problem of the Tamiya ones - but only on the last one, so I'm posting it up here in the hope that other people can learn from my mistakes! First of all, there's usually some spare metal transfer - in the Tamiya DBS case, a sort of sheet identifier number on a plaque. Don't ignore it! Just try applying some of this spare transfer to the surface or surfaces you need the real things to go on, and see if it goes on easily. If so, you're set. But if not, you haven't trashed a unique and fragile transfer in finding out (in my case,, "6.0 V12"). This is especially a problem since the elements of these transfers are not actually connected in any way once they are off the backing and cover film. The transfers are most likely to stick properly to a smooth, shiny surface. In the DBS decal sheet, there are several number plate frames where the clear decal film covers the whole area of the plate, but only the border is printed in colour (eg the Italian plate). I applied the metal transfer to some of the clear decal film. You can rub it down HARD on a flat, level surface and be sure that the thing has firmly stuck down. Then, cut the decal film close to the metal transfer and apply it like a normal decal. The glue on the transfer is not affected by the water. I used Klear as a setting solution, and the underlying decal film is completely invisible. Most kits have some spare decals with extra clear film, and if the specific kit you're building doesn't you've certainly got some in the spares box or stash of other kits that will... best regards, Matt Quote Link to comment Share on other sites More sharing options...
beancd5 Posted September 25, 2012 Share Posted September 25, 2012 thanks for the tip, I think I have a few to go onto my Tamiya skyline kit Quote Link to comment Share on other sites More sharing options...
Rich7284 Posted August 3, 2019 Share Posted August 3, 2019 Thanks for the awesome tip came in very handy on my Porsche 911 GT3. Quote Link to comment Share on other sites More sharing options...
935k3 Posted August 3, 2019 Share Posted August 3, 2019 I use this method to because it let's you move it around to the exact position. Otherwise you have to be exactly right the first time. Quote Link to comment Share on other sites More sharing options...
Tommy124 Posted August 5, 2019 Share Posted August 5, 2019 I keep using metal transfer parts of the smallest kind from Hobby Design for detailing door and trunk locks. So far applying them has been a pain in the BLAH every time because these small parts hardly have any adhesive themselves. I will try this method out, I'm positive it will facilitate the process. Thanks for sharing. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.