Search the Community

Here's another project that's been sitting around here, for a couple of decades. Interestingly, it's yet another Monogram model, as well! I gave consideration to redoing the California Street Vette, once the Mack was completed, but decided to go into the current quarterly "Bring Out Your Dead" thread, with this, instead. This was begun probably before the turn of the century--although I don't recall when, exactly. Since I took it back out of the box in pieces, I have done some work to the chassis. I added bottom frame tubes, and rebuilt the side bars in the cockpit, along with the fuel tank support/brackets. I'm not completely decided, as far as wheels. I like the dished Halibrands (I think that's what they are), but the two-piece wheels look cool, as well; Those, however, will need to be narrowed. I've made molds, in case I choose that direction, since I only have the pair, as well. I had already selected a set of nice Corvette valve covers for the car, so I will use them. Hilborn fuel injection. Quick-change rear from a Monogram sprint car. Although it's too small, I am using a steering box from one of the old MPC funny cars. It's not all that visible, anyway, and it fits! I removed the kit firewall and replaced it with aluminum flashing. I also removed the hood. I want to make it from flashing, as well. It's curvier than any sheet work I have done, before, so it will be a nice challenge! If that goes well, I may attempt the nose, as well. I'm unsure of the origin of the rear tires. I think they may be from an AMT Lotus or the Willard battery car. The fronts look like AMT's from the early '70s--they look like the tires from my original Pepper Shaker--and they may well be! I started work on a new front spring and axle. The headers will need to be redone, between the ports and the dumps. Since these photos, I have notched the lower firewall to clear the lower chassis tubes, removed the nose from the hood, and filled that hole on the right rear cage upright with acrylic nail resin. Speaking of the spring assembly: I've known this for a couple of years, now, and have mentioned it before, but it bears repeating--in bold Italics!: There is no better way to precisely apply liquid plastic cement (NOT superglue--MEK, etc.) than an insulin syringe. None! Don't tell me "I like this", or "I prefer that". There is absolutely no debate! ? Using the plunger, you can push out the tiniest drop of cement. Just touch the joint with that, and you're done. Need another tiny drop? Just squeeze out another, and go. No mess. No excess. Need to flood it on? Hey! That syringe has you covered. Anyhoo, without further ado... As always, questions, critiques and comments are welcomed and appreciated! Thanks for looking.