Tamiya Weathering Sets

[snacktruck67]

When using the Tamiya weathering pigments, is it necessary to spray a dullcoate of paint on the model to prevent the powder from rubbing off or will the pigment powder dry out and not rub off?

[Chillyb1]

You don't need to clear over the pigments because they don't really go on like other powders. 

[Mike Chernecki]

You don't need to clear over the pigments because they don't really go on like other powders. 

please expain. I have been interested in ordering these sets but not sure what they are like. Are they dry powder, pastel chalk, or like a very thick paint that bites and adheres to the surface ? 

[Yenkocamaro]

Hi Mike, I purchased one of these kits, and it turned out great. You can check my "Barn Find" 1/18- 69 Camaro, under Diecast cars section.

It is in a powder cake form, with an applicator. I scrapped a little out into a small plastic container that I saved from dipping sauce, and added just a touch of water. Then I used a fine paint brush to apply some rust in certain areas. I also scrapped some "dirt"( I think that's what they call it) from the kit into a very small spray bottle, and added some water, mixed it up, and sprayed down the car to add years of dirt falling on the car. When I was done, I did put a coat of dullcoat on the car just to make sure it stayed put under handling the car.

Cheers,

Lance 

[SfanGoch]

please expain. I have been interested in ordering these sets but not sure what they are like. Are they dry powder, pastel chalk, or like a very thick paint that bites and adheres to the surface ? 

Tamiya Weathering sets aren't powdery. They are greasy, like makeup or mascara. When applied lightly, they impart a good effect; although, just like pastels, you can't overspray them with a flat coat because they' absorb moisture from the fixative and darken, ruining the weathering effect. Also, just like pastels, they don't stand up to handling well and will lift off. MIG pigments are better for weathering because they can be washed into crevices and can be easily removed using a toothbrush. Plus, you don't need to use a clear coat to seal them.

[Mike Chernecki]

Lance And Joe,  Thanks for the info...I need to get some of these sets.