78 Corvette Street Out Law

[baddgass]

[baddgass]

http://Been out of the loop for a bit. But i started this kit about 4 mo. ago. it in 1/8 scale.

[baddgass]

[baddgass]

I have a lot of pics. to get you up to speed on this build.  I know we all like details , I will say Big In,s --------  Some my no the build from facebook .  Also have to say the frame so hard to do the way the drive sets --------- back in the body --------  you see.

[Len Woodruff]

Nice. I have a 1:1 78 Silver Anniversary in the garage. 

Edited February 1, 2016 by Len Woodruff

[baddgass]

[baddgass]

Some parts from TDR.

 

 

Edited February 2, 2016 by baddgass
Remover pics.

[MeatMan]

Looks like a nice project.  I've never seen anyone build a chassis like that, but I like it!  Great craftsmanship.

[baddgass]

Thanks meat.

 

[baddgass]

Some more parts from TDR.

[baddgass]

[cobraman]

Nice ! I will be watching this one for sure.

[drummerdad]

Nice. I love the outlaw cars. Ill be watching this one. 

[Red rocket 10]

Love what you've got going here ?

[baddgass]

Thanks Bros.

[baddgass]

[baddgass]

[baddgass]

[baddgass]

[baddgass]

[baddgass]

 A little back ground, This build was started ( 10/27/2015  ) All the pics. are from then to two mo. ago.  ------ Had a knee replace ------   Lots of mistake, cuttings, bends, re-dos as you can see in the pics.

 I'm going to post pictures fast to get caught up.                   Anything to say ---- good or bad ----- say it. lol    ( Iron sharpen Iron )

[baddgass]

Got my rims from Jim at Micro Nitro.    (Nice) !!!!!!

[LaughingIndian]

This is wild. What a beauty. Thanks for the show.

Do you use tube only or do you use rod for bends?

And how do you clean up the 3D print surfaces?

 

[baddgass]

Thanks Mike --- I do have more.    As for the tube, all plastic no rod for bends. Some I hand bend, some with a litter heat, and some with 90s and 45 elbow from Plastruct.                    

Look up this stuff   XTC - 3D  for clean.     Thanks all for looking in.

[baddgass]