Paint work

[Pau7060]

Hi am looking for some advice on painting this body. It's Flashpoint Resin Body . I  want too try and adapt this paint job this FRB body . What would progression for colors be for this paint job . Thanks 

Edited July 15, 2016 by Pau7060

[astroracer]

Spray the white over the entire car as a base coat.

Layout the magenta/orange, masking only the top of the car. This means spraying the entire side of the car in that color.

Now mask off the magenta/orange pattern and spray the black/blue.

 look into nail polish as your "paint". It's cheap, is lacquer based and the colors are endless...

Mark

[Pau7060]

Thanks mark

[Mike_G]

That's some pretty demanding masking

[astroracer]

  On 7/15/2016 at 10:05 PM, Pau7060 said:

Thanks mark

No problem. Use GOOD 3M Fine Line masking tape to mask you separation lines. If you want to prevent bleeding under the tape (even with the good tape this can happen) shoot a light coat of clear over your tape lines prior to shooting color. The clear will seal the tape and, if there is any bleed, it's clear and will not be seen.

Mark

[greger]

that is a very good tip. mark 

 

 

Edited July 16, 2016 by greger