Photo Etch 64 Dodge grille ?

[Jon Haigwood]

New to using PE Not had  a lot of success with the carb linkage PE parts yet (they seem to small).

I am about to do the grille on a 64 Dodge 330 and after looking at the instructions it seems to be a bit more involved than I thought'. I did a search and did not find any thing on doing a PE grille. Is their any tips or advice on this ?  Thanks 

[gtx6970]

Find a piece of tubing or rod and roll it over it ,,,slowly.

I did one may years ago and once done it looks great

[Jon Haigwood]

Find a piece of tubing or rod and roll it over it ,,,slowly.

I did one may years ago and once done it looks great

i plan on using the four headlight grille on this build and the two headlight grill on the next one. is there additional work for adding the inner lights?

[gtx6970]

i plan on using the four headlight grille on this build and the two headlight grill on the next one. is there additional work for adding the inner lights?

Dont know about that one. I used the 2 headlite grille for a Hemi car

 

[gtx6970]

Just as an FYI, technically the upper mldg of the grille should be attached to the leading edge of the hood and NOT  remain on the grille as shown here . But at the time I did this car I didnt realize that . Plus if u do that there's no support for the top of the photo etch grille

[Jon Haigwood]

Just as an FYI, technically the upper mldg of the grille should be attached to the leading edge of the hood and NOT  remain on the grille as shown here . But at the time I did this car I didnt realize that . Plus if u do that there's no support for the top of the photo etch grille

Thanks I think one this build I will do it the same as you.Maybe next tie I will do it correct. Thanks for the info