Duplicolor Paint Match Gloss Clear Curing Slow?

[crowe-t]

I sprayed Duplicolor Paint Match Gloss Acrylic lacquer Clear on a resin laser pistol prop(from the 1985 TV show 'V').  I sprayed the clear on about a month or so ago.  It's still a bit soft and not hardening too well.

Could it be since it's been very humid here in New York?  Is there anything I can do to help it along?  Perhaps hit it with a hair dryer a few times.

It took over 15 hours to mask off all the gray areas to spray the black so I really don't want to strip this one.  When I was priming it I had to use some Isopropyl Alcohol in the area with the yellow tape.  The tape is covering a clear acrylic rod.  The rod broke free and I had to use an Epoxy for plastic to glue it in.  The alcohol caused the acrylic rod to loosen.  So to avoid all this again I'd rather not strip it.  

Edited August 16, 2018 by crowe-t

[64SS350]

That should have dried in hours, and handle time maybe a couple of days. If it hasn't dried in a month, good chance it won't.

[crowe-t]

18 minutes ago, 64SS350 said:

That should have dried in hours, and handle time maybe a couple of days. If it hasn't dried in a month, good chance it won't.

It is dried but it's still a bit soft.  In my experience lacquer usually dries a bit harder.  I was able to handle it within hours after the clear was sprayed on.  I thought it would cure harder than it is.

Edited August 16, 2018 by crowe-t