Photo Etch saw handle

[porschercr]

Crazy Modeler Photo Etch saws... Any idea what size handle to use with them? The "Type A" handle used for #11 blades handle wont fit. (too small.)

[Ace-Garageguy]

Hmmmm...the MGC saws fit the little one. I'll have to look into that.

Edited September 16, 2019 by Ace-Garageguy

[stitchdup]

If you look among the novelties/gifts in shops you might find a set like I have. Its a 3 piece craft multi tool with screwdrivers,blades and pens but you can ignore most of that stuff. The handle is very handy though, it has a blade holder on each end that is just the right size for the smaller pe saws. I got mine as a gift but once I get back home again at the end of the week I can post a pic of what to look for.  I believe they cost about a tenner

[porschercr]

4 minutes ago, stitchdup said:

If you look among the novelties/gifts in shops you might find a set like I have. Its a 3 piece craft multi tool with screwdrivers,blades and pens but you can ignore most of that stuff. The handle is very handy though, it has a blade holder on each end that is just the right size for the smaller pe saws. I got mine as a gift but once I get back home again at the end of the week I can post a pic of what to look for.  I believe they cost about a tenner

Thanks Leslie.

[porschercr]

39 minutes ago, Ace-Garageguy said:

Hmmmm...the MGC saws fit the little one. I'll have to look into that.

Thanks Bill. Looks like I'll be using those instead.