Len Woodruff Posted May 18, 2020 Posted May 18, 2020 Is there a tutorial on adding windshield trim. I need to add it to a scratch built I am doing. Thanks in advance for help.
Chariots of Fire Posted May 18, 2020 Posted May 18, 2020 (edited) Len: Here is the way I added some trim to a windshield, or in my case trim around a back window. On my example the trim is a bit strong so I would recommend reducing it some but the idea remains. If your windshield is curved this might not work but if it is flat here we go. First find the centerline both vertically and horizontally on the window opening. Mark it as I did above on the body. Next take a piece of sheet stock of 0.020" thickness and place it inside the cab so that you can trace around the opening on the sheet. Get the sheet as close to the inside surface as you can. Then using the lines on the cab find the center vertically and horizontally on the sheet. Now trace around the outline of the window opening the width of what you want the trim to be. Here is where I would have made mine a bit thinner. Carefully trim the sheet to the outside lines being sure that the alignment marks vertically and horizontally are in place. Once it is cut out, bevel the outside edges of the trim blank to give it some roundness and then glue it in position using the marks on the cab and the sheet stock for alignment. Be sure you are spot on with this because it will become critical in the next step which is to cut out the inside of the trim blank to the inner lines you drew earlier. Don't go beyond the lines!! When the cutting is done you should end up with a thin edge that you can see from the inside of the cab. It is against this edge that you can lay the clear stock for the glass. Here' s the glass in position with the trim around it. As I said it could be thinner all around. I made up for that though, when I painted the cab. Instead of painting the entire trim piece black to simulate the rubber gasket I just did the inner part and a thin portion at the edge using a felt marker. That helped keep the black trim to a minimum. Hope this helps. Even if the windshield is curved you might be able to apply some of this to your project. Edited May 18, 2020 by Chariots of Fire
Len Woodruff Posted May 19, 2020 Author Posted May 19, 2020 Thanks for the post Charles. That does allow the glass to fit flush. I was thinking that I need to use some strips to do the windshield. Here is a pick of the windshield area. Len
Chariots of Fire Posted May 19, 2020 Posted May 19, 2020 I think that is doable. You have a template of the windshield area so it means you can get the correct outside shape. If you can apply the technique I suggested you should be able to get some results. What will you do first, glue in the blank that is in the windshield area and then use the template?
Len Woodruff Posted May 20, 2020 Author Posted May 20, 2020 Thanks again Charles. I will work on it and post some pics of the progress.
Bainford Posted May 23, 2020 Posted May 23, 2020 On 5/18/2020 at 10:28 PM, Len Woodruff said: Thanks for the post Charles. That does allow the glass to fit flush. I was thinking that I need to use some strips to do the windshield. Here is a pick of the windshield area. Len Interesting looking project.
Erik Smith Posted May 23, 2020 Posted May 23, 2020 Len - maybe you’ve seen this thread before, but in case you missed it... You can see how Shawn did the window trim on page two or so - which looks similar to where you’re heading.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now