leafsprings Posted November 6 Share Posted November 6 (edited) An early 60's Chevy 2 ton is now available, very similar to the old Modelhaus '64-'66 Chevy 2 ton. Would have liked to see a separate hood, but great to see. 1/25 3D print resin NOT CAST kit Chevrolet C60 1961 Truck | eBay Would look great teamed up with the AMT haulaway trailer. Edited November 6 by leafsprings 3 Quote Link to comment Share on other sites More sharing options...
zaina Posted November 7 Share Posted November 7 I offer it with an opening hood, engine, interior, and chassis with dump bed. 1 Quote Link to comment Share on other sites More sharing options...
leafsprings Posted November 19 Author Share Posted November 19 (edited) On 11/6/2023 at 9:26 PM, zaina said: I offer it with an opening hood, engine, interior, and chassis with dump bed. Didn't now that Andy, would have purchased them from you, just received the DiOlex version, it is very nice! Any possibility of doing the '60-'61 GMC version? GMC would just need a hood , V6 emblem and grill. Or the '62 Chevy version? Chevy would just need a hood and grill. Using our creativity, a dual drive set up could be pirated from donor kits for a Heil dump body or Challenge mixer body. Edited November 19 by leafsprings 1 Quote Link to comment Share on other sites More sharing options...
dustym Posted November 20 Share Posted November 20 (edited) I just seen this yesterday and thought it was very nice. Are the files already pre-supported? I suck at creating supports. Thanks, Tim Edited November 20 by dustym Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.