kitbash question

[thatz4u]

how difficult is it to put an AMT 41 Ford woodie front clip on a Revell 48 Ford???

[milo1303s]

it has been done this here is a custom 

and another 

I'm sure these guys will chime in and let you know how bad or easy it was !!! lol

Edited April 16, 2024 by milo1303s

[Ace-Garageguy]

Few years back I started doing two similar swaps, '41 nose on a resin '48 4-door based on the Revell kit, and another '41 nose on the infamous IMC/Testors '48 that was getting lead-sleaded.

Neither one seemed to be particularly difficult as far as I can remember, which is as it should be, 'cause in reality it's almost a straight bolt-on...other than the running boards.

Just measure carefully and work slowly and pay attention to fit as you go.

[bobss396]

The factory '41 to the '46-'48 post-war cars were quite similar in the 1:1 world. I would consider doing one. Now if someone would make up a 3D printed '42 grille...