Quick Q for Michael (dirtmodeller) or someone with his 1/16 drag sets

[stump]

Hey guys, this post can be deleted real quick if I can gain a quick response.

Ok, I have some of Michael's 1/16 drag parts on their way. Engine plates, rear end plates and some Dzus tabs..oh, plus a seat.

I already have a Camaro (70.5) in the work shop with the two main chassis rails done.

Could someone please give me a measurement of the 4-link brackets.??

Top to bottom, either including the notches (for the frame) or without. I should be able to work it from there.

I know I could just wait it out......but I'd really like to get in and have the chassis to a stage where I can just "add" them when they arrive.

Any help would be great, and thanks in advance.

[eviltwincustoms]

Could someone please give me a measurement of the 4-link brackets.??

Top to bottom, either including the notches (for the frame) or without. I should be able to work it from there.

Greg, I think I can help you out buddy! There are actually two different sets that can be used and will give you a bit of a difference in measurement.

The ones I used, I will supply you the measurement Center to Center of top and bottom tubing = .7670"

Or the Top to Bottom you requested is 0.6525"

On the other set the Top to bottom is 0.6825", I didn't use these because the holes are to small and to close together for the 00-90 threaded screws.

Hope this helps!

[stump]

Bart, that is perfect my friend.

Gives me a clearer indication of where the upper bars/mounts need to go. I'm on it..............

Thanks heaps mate.