GM heater hose bracket

[haro85]

Does anybody have any good ideas on how to create the heater hose bracket that was found on most GM cars in the late 60s? It attached to the passenger side inner fender and held both heater hoses out of the way. Pictures would be great.

Kevin

[1930fordpickup]

Masking tape might work. Just paint it black.

A small piece of a soda can painted black. Just trim it up and bend around two small nails side by side.

[my80malibu]

Sometimes I use the Photo etched surround of PE detail sets to fashion a strap trapping both hoses together. Chrome/Aluminum flashing tape works well too.

[espo]

Do you have a Michele's or Jo-Anns near you ? I have used items from their jewelry department. They carry many gauges of wire. They also have something that looks like a straight pin with a loop on the end. You can cut off most of the straight part. Use that to glue to a small hole drilled to the inner fender and run the heater hose thru the loop. The loop can be easily bent or reshaped as need be. Hope this is of some help.

[haro85]

That does help. Thank you very much.