Ideal Glue for Resin bed

[kmc3420]

This is my first go at using Resin. I am assembling a 68 C10 bed, what is the ideal glue/epoxy for resin?Thanks.

I have testors super glue that dries within seconds, I have Tamiya ultra thin cement, and Bob Smith quick set epoxy, its two part. What would be my best course of action, thanks.

[misterNNL]

The last three models I finished were based on resin offerings from either Jimmy Flintstone or Model Martin and all were assembled completely using super glue and there were no problems.

[BubbaBrown]

Super glue first, if you need a stronger joint use epoxy or use epoxy on top of super glue.

[kmc3420]

Thanks Tom and Joseph, super glue it is. I have a few small gaps to fill and might use the epoxy for filling gaps.

[Warren D]

Don't use solvent glue for styrene,   I've had good results with all varieties of super glue.

[Chariots of Fire]

What they said!  Superglue.  You might try minimum superglue in the gaps as well and then sand right away.  The sanding particles will mix with the glue to fill the gap solidly.  Epoxy may not set up hard enough for you to sand it well.

[kmc3420]

Thanks all for the suggestions, I did get the bed super glued together, and filled the gaps with the two part epoxy that sets up in 15 minutes. It is very solid. I was able to brush the epoxy mixture from the bottom side and it filled the gaps very nicely. Just need to do a bit of sanding in the corners where the bedsides/floor meet.