55 Chev Cameo

[bandit1]

Let's see what Y'all did or in the progress of working on your kit... I NEED INSPIRED!?

[Tom Geiger]

Hey, you asked an open ended question... these two were built when the kit was first released eons ago....

A flaw on this kit that you may want to fix... look at the relationship between the body and the interior tub.  There is space around the two sides and rear that you can see up inside the body!   I added plastic at the rear, and the step to either side.  I'm not sure my step is absolutely correct, but back in the 1980s you were flying without the Internet!

and here's the nose of one...

[Tom Geiger]

 

And through the magic of the Internet, here's what that floor should look like.  I see the step should be shorter and the back panel goes all the way across.

I'll have to build another one!

[Belugawrx]

I dropped mine onto a Nascar front end and engine....

[Flynlo]

Here is one that I did with a ZR-1 Corvette drivetrain and added 55 sedan side trim:

 

Edited September 29, 2018 by Flynlo
typo

[avidinha]

I kind of went a different way with mine.

 

[Flynlo]

sweet!

[bandit1]

On 9/29/2018 at 11:50 AM, Flynlo said:

Here is one that I did with a ZR-1 Corvette drivetrain and added 55 sedan side trim:

 

Neat, How did you do that trim? Is it scratched or grafted from the 55 Chev kit or??

[Flynlo]

The Revel 55 car has the trim molded separately. with a little persuasion it fit the contour of the bed sides and blended with the forward spear on the door